Hitec D954SW Multi Purpose Servo

Code: HT-01-02-D954SW-Multi-Purpose-Servo

The power of Hitec’s D-Series servos continues with the introduction of the next Premium Class trio: the D930SW, D954SW and D955TW. As with the entire “D” line, these technologically-advanced servos are powered by a 32-bit MCU (Microcontroller Unit) and 12-bit ADC (Analog to Digital Converter) industrial science and possess Smart Sense engineering with rapid, high resolution response. Their unprecedented programmability and wide-voltage capabilities deliver the most progressive, leading-edge performance for all your radio control needs. Built with incredibly durable steel gears, the D930SW are the perfect upgrade from our popular HS-7954SH servo. Advancing servo technology and providing superior engineering has always been Hitec’s mission and that continues today as Hitec expands their outstanding D-Series product

Features:

• Speed: @4.8V .19sec/60' / @7.4V .12sec/60'

• Torque: @4.8V 251oz/in / @7.4V 405oz/in

• Programmable PWM Digital Amplifier

• 32-Bit MCU with 12-Bit ADC Circuitry

• 4096 Resolution

• 1M Cycle Long Life Potentiometer

• Wide Operating Voltage (4.8 ~ 8.4 Volts DC)

• Dual Ball Bearing Supported Output Shaft

• 25-Tooth Output Spline

• Coreless Metal Brush Motors

• Nylon Reinforced Plastic Upper and Lower Case

• Diamond Cut Aluminum Heat Sink Center Case

• Dust Resistant and Splash Proof Case

Specification:

• Control system - PWM

• Position sensor type - Contact Analog Potentiometer -

• Operating voltage range - 4.8 ~ 7.4 V -

• Motor type Coreless - Metal Brush

• Voltage - 4.8V/6.0V/7.4V

• No load speed - 0.19sec/60˚/0.15sec/60˚/0.12sec/60˚

• Stall torque - 18.0 kgf·cm(249.97oz·in) / 24.0 kgf·cm(333.3 oz·in) / 29.0 kgf·cm(402.73oz·in)

• Standing current - 30mA 30mA 30mA

• No load running current - 300mA 400mA 500mA

• Stall current - 3,200mA 4,200mA 5,200mA

• Dead band width - 1usec 1usec 1usec

• Operating travel - ±40˚/One side pulse traveing 400usec -

• Operating temperature range -  -20˚C ~ +60˚C (-4˚F ~+140˚F) -

• Storage temperature range -  -30˚C ~ +80˚C (-31˚F ~+176˚F) -

• Connector wire length - 300mm (11.81inch)

• Connector wire gauge - 20AWG

• Dimensions - 40.0 mm x 20.0 mm x 37.0 mm ( 1.57inch x 0.78inch x 1.45inch ) Refer to the tolerance information

• Weight - 65.0 g( 2.29oz) Excluding the weight of Horn below

• Ball bearing - 2 Ball Bearing -

• Case material - Engineering Plastic & Aluminum Heat Sink -

• Gear material - 1 Metal + Plastic & 3 Steel -

• Gear train backlash - Max 0.5˚ -

• Horn gear spline - 25T(Ø6) -

• Servo Amplifier type - 32bit programmable Digital

Package contains: 

• 1x D954SW Standard Digital High Torque Steel Gear Servo